| |
Untitled Document
|
|
|
Untitled Document
|
|
 |
 |
홈 > 데드스루 |
|
|
|
|
|
|
|
|
 |
|
|
| DedTru Precision Centerless Grinding Units are designed
to be used in high volume production, tool rooms or job
shop applications and produce one-of-a-kind prototype
parts in either small or large quantities. Operators do
not need specialized skills to operate this equipment.
Three Dedtru models are available as shown below. These
models utilize a method known as climb grinding where
coolant is carried between the grinding wheel and the
part. Using this grinding technique, the amount of heat
transferred to the material is minimized resulting in
an extremely accurate part with a superior finish. New
Unison can supply off-the-shelf tooling for diameters
ranging from .005” to 5.000”. |
|
| |
 |
|
Pictured above is a
Model C used for throughfeed, infeed and secondary
operations which has a 4 inch wide regulating roll
& blade.
A complete line of DedTru accessories is available
to accommodate your production requirements. |
|
|
|
|
| |
 |
| For larger parts a Model C6 is used for throughfeed,
infeed and secondary operations and has a 6 inch
wide regulating roll & blade. |
|
Wheel Balancing
Equipment
Wheel Dressers
Including Line Straight Angular, Radii, Form, Template
& Optical
Tiltru Magnetic Chucks
Work Blades & Guides
Work Supports
Splash Pans
Pressure Rolls
End Stops
Part Adaptors
Start/Stop Control of Regulating Roll
Coolant Accessories FilTru Tank, FilTru Paper, Spare
Parts, etc. |
|
 |
| The Model PGF is used for infeed and secondary
operations of parts which have multiple diameters,
gears, splines, etc. that require a relieved regulating
roll, blade, etc. The Model PGF allows the operator
easier access to the end of the part for ID grinding
applications. |
|
|
 |
Above is a Model IGF used for applications that require
grinding the ID of parts closely concentric to the OD.
Concentricity is automatic with the IGF once the unit
has been installed and properly aligned. It provides ease
of set-up and does not require close supervision during
production. This unit can easily accommodate long or short
parts and uses a standard regulating roll of 5" diameter
and 2" wide.
Could
your DedTru use a rebuild? All rebuild
Dedtru Units are disassembled, thoroughly examined, cleaned
and inspected. All parts, which do not pass inspection,
are replaced. Normally DedTru Units can be rebuilt in
a week. However, if you should have a breakdown and need
a rebuild under emergency conditions, call us. Breakdown
service is scheduled as top priority. To keep your DedTru
in top condition, you should have it rebuilt every two
to three years. |
|
| |
| |
|
|
